Re: [LAU] Setting up and using E-Mu 1212m (emu10k1) soundcard

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]
To: linux audio users <linux-audio-user@...>
Date: Wednesday, April 17, 2013 - 1:25 am

On Tue, April 16, 2013 9:36 am, Julien Claassen wrote:

12 and 12 at 48000 or 44100s/s.

I know for the delta (1712 based cards) the maximum i/os always shows up
12/10.

I am not so sure with this unit. even with the delta1010/66/44 if you are
using the gui controller (I know you have not seen that) It shows only the
number of adcs and dacs there are (I have a D66). In the monitor mixer
section it shows all the outputs, but only real inputs. You may have some
of the same.

There may be some reason the adat shows only outputs until it is
connected... then it may be 8, 4 or 2 channels depending on rate. (only 8
inputs up to 48k) Or it may be 2 inputs if it is being used as a second
spdif (total of 6 i/o). The real question in my mind is what inputs are
really there in the 8 channels you have now? The pcie1010 reconfigures
itself quite dramatically depending on what is plugged in. Plugging the
dock in makes some of the plugs on the pcie card inactive for example. The
dock and the daughter card can not be used together either.

I think you will find the 16 outputs are there just because they are mixer
inputs. The inputs? I would assume either spdif l/r then ch 1/2 NC 3/4/5/6
or ch1/2 NC 3/4/5/6 and spdif l/r.

I think the adat would have to be plugged in before the system start and
already set to the rate you were going to use as I don't think (correct me
if I am wrong) alsa can dynamically change the number of ports a device
has and jack would find that a problem too. Do you have the bits to test
what is what?

--
Len Ovens
www.OvenWerks.net

_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-user

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]

Messages in current thread:
Re: [LAU] Setting up and using E-Mu 1212m (emu10k1) soundcard, Len Ovens, (Wed Apr 17, 1:25 am)