Re: [LAU] Fluidsynth map channels to audio outputs?

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]
To: <linux-audio-user@...>
Date: Friday, January 18, 2013 - 11:05 pm

On Friday 18 January 2013 21:52:40 Lorenzo Sutton wrote:

synth.audio-groups

Integer. [min=1, max=256]. By default, the synthesizer outputs a single stereo
signal. Using this option, the synthesizer can output multichannel audio. This
value should be the same as "synth.audio-channels" unless LADSPA is enabled,
then it will be the number of inputs to the LADSPA subsystem.

If you set this number to 16, each MIDI channel will be mapped to a separate
stereo output. If the number is less than 16 then audio_output# = MIDI_channel
module audio_groups.

Regards,
Pedro

_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-user

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]

Messages in current thread:
[LAU] Fluidsynth map channels to audio outputs?, Lorenzo Sutton, (Fri Jan 18, 8:52 pm)
Re: [LAU] Fluidsynth map channels to audio outputs?, Pedro Lopez-Cabanillas, (Fri Jan 18, 11:05 pm)