Re: [LAD] (Modular) Synth and Clipping

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]
To: <linux-audio-dev@...>
Date: Saturday, June 15, 2013 - 9:33 pm

Le Sat, 15 Jun 2013 21:48:40 +0100,
John Rigg a écrit :

> On Sat, Jun 15, 2013 at 08:50:39PM +0200, Dominique Michel wrote:

Me too, and I repair them too. I was talking here about cheap power
transformers used in some brands of commercial guitar amplifiers, not
about their output transformers. The main frequency is low enough to
easily saturate them when they are not properly dimensioned, and this
saturation will go through everything to the speaker.

A typical example are the old Peavey Mace, good transistor preamp and
driver stage, 6x6L6 for the output, but a too small power transformer to
drive such a power (160 w RMS), and a bias circuit for the power stage
that kill the dynamic when it is in saturation. The power transformer is
definitely too small to drive the tubes at full saturated volume. I
measured such an amp, the maximum power is the same with a clean sound
and at full saturation. The sound is very good when the power stage is
not saturated, but very bad when the power stage is saturated, that
not only because of the lack of dynamic, but also because of the
saturation of the power transformer.

Excellent amplifier for jazz music - due to its large power, you can
even use it in small places with a mixer and put a whole gang on it -
but not for rock or blues. Even a small Fender Champ give a much better
sound at full volume. On the other hand, the output transformer of the
Champ is too small, and you will change it as often than the power
transformer of a Mace when playing loud, but the sound will be much
better. It was some years ago, one of my clients was "using" one
output transformer each year with his Champ.

Dominique

>

--
"We have the heroes we deserve."
_______________________________________________
Linux-audio-dev mailing list
Linux-audio-dev@lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-dev

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]

Messages in current thread:
[LAD] (Modular) Synth and Clipping, Aurélien Leblond, (Sat Jun 15, 1:56 pm)
Re: [LAD] (Modular) Synth and Clipping, Tim Goetze, (Sun Jun 16, 10:57 am)
Re: [LAD] (Modular) Synth and Clipping, Fons Adriaensen, (Sun Jun 16, 11:58 am)
Re: [LAD] (Modular) Synth and Clipping, Dominique Michel, (Sat Jun 15, 6:50 pm)
Re: [LAD] (Modular) Synth and Clipping, John Rigg, (Sat Jun 15, 8:34 pm)
Re: [LAD] (Modular) Synth and Clipping, Dominique Michel, (Sat Jun 15, 9:33 pm)
Re: [LAD] (Modular) Synth and Clipping, John Rigg, (Sun Jun 16, 10:59 am)
Re: [LAD] (Modular) Synth and Clipping, Dominique Michel, (Sun Jun 16, 7:15 pm)
Re: [LAD] (Modular) Synth and Clipping, Fons Adriaensen, (Sat Jun 15, 9:24 pm)
Re: [LAD] (Modular) Synth and Clipping, John Rigg, (Sat Jun 15, 4:22 pm)