On Mon, Oct 11, 2010 at 03:31:58AM +0400, alex stone wrote:
> On Mon, Oct 11, 2010 at 3:13 AM, wrote:
None of this means you need to use more than one reverb, and if
the target is to have more consistency you definitely should use
Reverb is a linear operation.
If F1, F2, F3 are linear operations (EQ, delay, gain), then
F1 (reverb (x1)) + F2 (reverb (x2)) + F3 (reverb (x3))
is the same as
reverb (F1 (x1) + F2 (x2) + F3 (x3))
which uses just one reverb.
* Set the reverb to 100% 'wet' and connect the outputs to your
main mixing bus.
* Send controlled amounts of each channel/group/section (after
fader) to the reverb input. You can even equalise or delay
There are three of them, and Alleline.
Linux-audio-dev mailing list